Velleman VRC801D2 - Manual (Page 5)

VRC801D2 VELLEMAN
- 5 -
b. Locking the Volume
Enable this function when you only use one device to adjust the volume.
• Hold the SET key pressed for 3 seconds.
• Select CONFIGURE using the or the button and
press OK.
• Select VOL LOCK using the or the button and press
OK.
• Select the device key corresponding to the device
• Select ON or OFF using the or the button. Press OK
to confirm.
• Press EXIT to quit.
c. Locking the Device
Enable the device-lock function to lock the code of your device. This code will not be modified during an automatic code
search.
• Hold the SET key pressed for 3 seconds.
• Select CONFIGURE using the or the button and
press OK.
• Select DEV LOCK using the or the button and press
OK.
• Select the device using the corresponding device key.
• Modify the status using the or the button. Press OK to
confirm.
• Repeat the 2 steps above to lock other devices if desired.
• Press EXIT to quit.
d. Backlight
When the backlight is activated, the backlight will light every time a key is pressed.
• Hold the SET key pressed for 3 seconds.
• Select CONFIGURE using the or the button and press OK.
• Select LIGHT using the or the button and press OK.
• Select ON or OFF using the or the button and press OK to confirm.
• Press EXIT to quit.
e. Adjusting the Contrast of the LCD
• Hold the SET key pressed for 3 seconds.
• Select CONFIGURE using the or the button and press OK.
• Select CONTRAST using the or the button and press OK.
• Set the contrast using the or the button and press OK to confirm.
• Press EXIT to quit.
f. ShowView Function
The VRC801D2 features a ShowView function with which you are able to scan all TV or CAB/SAT channels.
• Press the device key first.
• Hold the SHOW VIEW key pressed. The remote control automatically scans all channels as soon as the LED flashes.
Remark: - Point the remote control to the device during the entire operation.
- Press any key to exit the ShowView mode.
g. All Off Function
This key allows you to turn all devices on or off with a single press. Point the remote control towards the device and hold the
ALL OFF key pressed.
h. Clear All
Use this function to erase all the data and return to the factory settings.
• Hold the SET key pressed for 3 seconds.
• Select CONFIGURE using the or the button and press OK.
• Select CLEAR ALL using the or the button and press OK.
• SURE CLEAR appears on the LCD. Press OK to confirm. All your settings have been deleted.