Velleman LX101 - Manual (Page 7)

LX101
V. 01 – 06/06/2012 7 ©Velleman nv
6. Press <ENTER> and use <UP> or <DOWN> to set the strobe effect (off) ~ (max.).
7. Finally, press <ENTER> to confirm. Note that you will have selected the first colour. Simply press
<MENU> to exit.
Dimmer speed setting
1. Press <MENU> until
is displayed.
2. Press <ENTER> to confirm your selection.
3. Use <UP> or <DOWN> to select the desired dimmer speed (
, ~ ).
4. Press <ENTER> to confirm your selection.
7.4 DMX Mode
This mode allows you to control the fixture by any universal DMX controller.
• All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to “listen” to
the DMX controller. The same starting address can be used for a whole group of devices or an
individual address can be set for every device.
• When all devices have the same address, all the units will “listen” to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set individual addresses, each device will “listen” to a separate channel
number. Changing the settings of one channel will only affect the device in question.
o
In case of the 3-channel LX101, you will have to set the start address of the first unit to 1
(CH1~3), the second unit to 4 (1 + 3) (CH4~6), the third to 7 (4 + 3) (CH7~9), and so on.
o
In case of the 4-channel LX101, you will have to set the start address of the first unit to 1
(CH1~4), the second unit to 5 (1 + 4) (CH5~8), the third to 9 (5 + 4) (CH9~12), and so on.
o
In case of the 9-channel LX101, you will have to set the start address of the first unit to 1
(CH1~9), the second unit to 10 (1 + 9) (CH10~18), the third to 19 (10 + 9) (CH19~27), and
so on.
1. Press <MENU> until is displayed.
2. Press <ENTER> to confirm your selection.
3. Use <UP> or <DOWN> to set the number of DMX channels (
, or )
4. Press <MENU> until is displayed.
5. Press <ENTER> to confirm your selection.
6. Use <UP> or <DOWN> to select the desired DMX starting address (
~ ).
DMX Channel Values
9-Channel Mode
channel function from to description
1 master dimmer 000 255 0 ~ 100%
2 red 000 255
0 ~ 100%
(or step time for auto program)
3 green 000 255
0 ~ 100%
(or fade time for auto program)
4 blue 000 255 0 ~ 100%
5 colour macros
000 010 no function
red green blue
011 255 100% S 0%
031 050 T 100% 0%
051 070 0% 100% S
071 090 0% T 100%
091 110 S 0% 100%
111 130 100% 0% T
131 150 100% S S
151 170 T T 100%
171 200 100% 100% 100%