Velleman LPTDX1220 User Manual
Velleman Lighting
LPTDX1220 GB
1
LPTDX1220 – 12-CHANNEL DIMMER PACK
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the LPTDX1220 ! Please read the manual carefully before bringing this
device into service.
Maintenance is easy and the LPTDX1220 features 12 DMX channels, dimming and switching
modes, modular construction 12 x 20A in 3 phase systems, analogue or DMX control and 0-10V
or DMX input.
Make sure that the device was not damaged in transit. If the device is damaged, you should
contact your dealer and postpone installation of this device.
2. Safety Instructions
• A qualified technician should install and service this device.
• Damage caused by disregarding certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for the ensuing defects or problems.
• Do not switch the device on immediately if it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room
temperature.
• This device falls under protection class I. It is essential, therefore, that the device be earthed.
A qualified person must carry out the electric connection.
• Make sure that the available voltage does not exceed the voltage stated in the specifications.
Protect this device against rain and moisture
Unplug the supply cable before opening the housing
Be very careful when installing the device : touching
live wires can cause life-threatening electroshocks.
Do not touch the device during operation as the housing heats up