Velleman LPTDX1220 - Manual (Page 6)

LPTDX1220 GB 6
SETTING 1 : PREHEATING
SETTING 2 : DIMMED / SWITCHED
SETTING 3 : SCENE PROGRAMMING
SETTING 4 : SET FADER TIME
SETTING 5 : LIST OF FADER TIMES
SETTING 6 : SET SQUARE LAW OR LINEAR DIMMING CURVE
SETTING 7 : SETTING MAXIMUM OUTPUT WATTAGE
Locking the keyboard : Press MODE + FUN + ↓ simultaneously
Unlocking the keyboard : Press MODE + FUN + ↑ simultaneously
Three Different Modes
Mode 1 : DMX
The display reads :
d = DMX
001 – 512 = DMX start addresses
←
: decrease the DMX start address of a channel
→ : increase the DMX start address of a channel
↑ : increase the DMX start address by 12
↓ : reset to d001
SEL : confirms the selected channel
SET : access to different settings
CAN : cancels current operation and return to the previous confirmed one
MODE : switch to analogue mode
Assign a start address to each LPTDX1220 when connecting multiple LPTDX1220’s to a DMX
control panel. This address determines the channels used by each LPTDX1220.
Example :
Device #1 : start address = d001, DMX channels used : 01 - 12
Device #2 : start address = d013, DMX channels used : 13 - 24
Device #3 : start address = d025, DMX channels used : 25 - 36
A resistor should terminate the DMX connection. Put the ON/TERMINATE selector in the ON
position.
Mode 2 : Analogue
The display reads :