Velleman Central Management System - Manual (Page 28)

25
8. DVR / PTZ CONTROL
8.1 DVR Control Panel
When the selected device is a DVR, click or to show the DVR control panel for remote control. For the
function of each button, please refer to the following description.
Note: The control panel below is taking a 16CH DVR model as an example and for reference only.
Some buttons may not be enabled or appeared for selected models.
Button
Function
Simplified Full Function
Description
Remote
Independent
Mode
Click to activate / deactivate the network independent function.
When this function is on, this button and the channel number buttons will turn to
blue, and you can switch to any channel of the selected device you want to see
without changing the channel display mode on the local site.
To exit the remote independent mode, click this button again.
Channel
Number
1~16 / 1~8 / 1~4 1~16 / 1~8 / 1~4 Click the channel number to switch to the live view of the selected channel.
Enter
Click to confirm the setting or enter your selection.
Menu
Click to enter the DVR OSD menu.
Arrow Keys
/ / /
/ / /
Click to:
1. Move the highlight up / down / left / right.
2. Make selection.
Event Search
Click to get access to the time & event search mode of the selected device.
R.E.T.R
Click to activate the R.E.T.R. function.
Audio Channel
Selection
/ /
Click to switch to the audio channel you want. The selected channel is shown as
green.
To know whether your device supports the audio function, please refer to the user manual
of your device.
To adjust the live audio volume, please refer to “ 4.4 Live Audio Volume Adjustment” at
page 13.
R.E.T.R. Audio
/ / When the R.E.T.R. function is selected and activated, the R.E.T.R. audio function
will be on, too. If you don’t want to activate this function, click the red icon again to
disable this function.
Video Channel
Selection
Click to display CH1, CH2, CH5 and CH6.
Click to display CH3, CH4, CH7 and CH8.
Click to display CH9, CH10, CH13 and CH14.
Click to display CH11, CH12, CH15 and CH16.
Click to display the 1st channel of the selected 4-cut view mode.
Click to display the 2nd channel of the selected 4-cut view mode.
Click to display the 3rd channel of the selected 4-cut view mode.