Velleman Central Management System - Manual (Page 38)

35
Function Description
DEVICE Choose “PTZ” when the connected camera is “PTZ”.
ID Set the ID number (0 ~ 255) of the connected PTZ camera.
PROTOCOL Choose “NORMAL”, “P-D” or “P-P” protocol. Please choose “NORMAL” if it’s our brand’s
PTZ camera.
RATE Set the baud rate of the camera (2400 / 4800 / 9600 / 19200 / 38400 / 57600 / 115200).
9.4.3 Detection
Select the desired channel, and click “Edit” or double click the item to enter the motion
detection sensitivity and area-setting page.
Function Description
DETECT Enable (ON) or disable (OFF) the function of “Motion Detection”.
If this function is enabled, you might need to set the motion detection sensitivity or simply
keep the default values. For details, please see the description below.
Motion Detection
Sensitivity
(LS / SS / TS / RE)
Set the detection sensitivity in 4 different adjustable parameters (LS / SS / TS / RE). For
details about each parameter, please refer to the user manual of your DVR.
Alarm Select N.C. (normal closed) / N.O. (normal opened) / OFF for the alarm polarity. For N.C.
/ N.O. contact details, please refer to the pin configuration description in the user manual
of your DVR.
Motion Detection
Setting Area Set the motion detection area by selecting the area grids with your mouse. Pink grids
represent the area that is not being detected while the transparent grids are the area
under detection. You can set multiple areas under detection.
Click “－” (Clear All) to set the whole area undetected.
Click “＋” (Select All) to set the whole area under detection.
Apply / Return To save the setting, click “Apply” and return to “Server Setting” window.
To discard the setting, click “Return” to directly return to “Server Setting” window without
saving.
9.4.4 Record
You can select the recording settings of your DVR.
Note: The options displayed here may vary based on the device you selected.