Panasonic WV-NF284 - Manual (Page 22)

22
• When using PoE (Power over Ethernet: IEEE802.3af compliant)
Connect a LAN cable (category 5 or better) between a PoE device (such as a PoE hub) and the
network connector of the camera.
Important:
• Use all of 4 pairs (8 pins) of the LAN cable.
• The maximum cable length is 100 m.
• Make sure that the PoE device in use is compliant with IEEE802.3af standard.
• When connecting both the AC 24 V/DC 12 V power supply and the PoE device for power
supply, PoE will be used for power supply.
• When disconnecting the LAN cable once, connect the cable again after 2 seconds or more
from the disconnection. When the cable is connected before 2 seconds passed, the power
may not be supplied from the PoE device.
• Refer to the provided slip (Recommended network devices for PoE (IEEE802.3af compli-
ant) connection with the WV-NF284) for applicable PoE devices.
Step 3
Connect a LAN cable (category 5 or better)
to the network connector on the mounting
side of the camera.
Step 4
Connect an external device.
q Remove 3 mm – 7 mm of the outer jacket
of the cable from the external device and
twist the core of the power cord to pre-
vent a short circuit.
Specification of cable (wire):
AWG #16 - #28 Single core, twisted
w Loosen the screws of the provided exter-
nal I/O terminals plug and insert the
cables from the external device into the
external I/O terminals plug until the
exposed core wires are completely hid-
den.
e Tighten the screws to fix the inserted
cables.
* Make sure that the exposed core wires
are completely hidden after tightening
the screws.
Network connector
1 2 3 4
External I/O terminals plug
(provided as a standard
accessory)
Approx. 3 mm - 7 mm