Panasonic WV-NF284 - Manual (Page 30)

30
Step 1
Start the Panasonic IP setting software.
Step 2
Click the [IP setting] button after selecting
the MAC address/IP address of the camera
to be configured.
Note:
When using a DHCP server, the IP
address assigned to the camera can be
displayed by clicking the [Refresh] but-
ton of the IP setting software.
Step 3
Complete each network setup item and click
the [Apply] button.
Note:
When using a DHCP server, it is possible
to set "DNS" to "AUTO".
Important:
• It may take around 30 seconds to com-
pletely upload the settings of the camera
after clicking the [Apply] button. The set-
tings may be invalidated when the AC 24
V or DC 12 V power supply is cut or
when the LAN cable is disconnected
before completing the upload. In this
case, configure the settings again.
• When using a firewall (including soft-
ware), allow access to all UDP ports.