Banks Power Pyrometer - Manual (Page 2)

2
| 9 6 3 2 5 v . 5 . 0
General Installation Practices
1.
This manual is an
installation guide for all Banks
DynaFact pyrometer gauges.
For ease of installation and
to determine what additional
tools or materials you will
need, read the entire 8–page
manual before starting any
work. NOTE: there are
portions of the installation
procedure and certain
illustrations matched to
specific vehicle types. For
proper installation, select
the text and illustrations that
most closely correspond to
your vehicle. If you cannot
correspond your vehicle to the
text provided, please contact
customer Service at (626) 969-
9600 for assistance.
IMPORTAnT! Anytime
the vehicle is raised off
its wheels, it should
be supported by safety
stands or ramps of
adequate capacity for the
vehicle’s weight. never
perform any work under
a vehicle supported only
by its service jack or a
hydraulic jack. Do not use
concrete blocks or other
masonry items that may
collapse under the vehicle
weight.
2.
Position wires and hoses
away from exhaust heat,
moving parts, and sharp edges
that may cause cuts or other
damage. Route or tie all wires a
minimum of six (6) inches from
hot exhaust parts; eight (8) or
more inches is recommended
where possible.
Dear Customer,
If you have
any questions
concerning the
installation of the
Banks DynaFact
Pyrometer Gauge
please call our
Technical service
Hotline at (888)
839-2700 between
7:00 am and
5:00 pm (PT). If
you have any
questions relating
to shipping or
billing, please
contact our
Customer service
Department at
(888) 839-5600.
Thank you.