Monster exhaust system installation – Banks Power 2011 Chevy_GMC 6.6L LML Duramax ECSB, ECLB, CCSB & CCLB including Dually models Turbo-Diesel Pickups User Manual
Page 5
96573 v.10.0
5
1.
As a precaution, disconnect the
ground of the battery (if there is more
than one battery, disconnect both).
2.
Raise the vehicle and support it
with properly weight rated safety
stands, ramps or a commercial hoist.
Follow the manufacturer’s safety
precautions. Take care to balance the
vehicle to prevent it from slipping or
falling. When using ramps, be sure the
front wheels are centered squarely on
the topsides; place the transmission in
park; set the parking brake and place
blocks behind the rear wheels.
CAUTION: DO NOT WORK UNDER
ANY VEHICLE SUPPORTED ONLY
BY A JACK. SEVERE INJURY MAY
RESULT.
WARNING! The following step may
require the use of a torch and/
or saw. Proper safety equipment
should be used. Failure to use
proper safety equipment may
result in severe injury.
3.
The factory exhaust pipe will be cut
behind the Factory Diesel Particulate
Filter (DPF) based on the configuration
of your vehicle. See Table 1. Measure
from the welded seam on the rear of
the DPF to the back of the vehicle. See
Figure 2. Take time when measuring
and cutting the factory pipe to ensure
the proper location and a straight cut.
Improper cut will result in poor fitment
of the Banks Monster exhaust system.
Monster Exhaust System Installation
2011 CHEVY/GMC 6.6L DURAMAX LML
Vehicle Configuration
Wheel
Base
2011
Measure behind DPF to the back of the
vehicle. Cut Exhaust pipe at Cut line.
See Figure 2.
Extend Cab Standard Bed
144”
7”
Extend Cab Long Bed
158”
14”
Crew Cab Short Bed
153”
12”
Crew Cab Long Bed
168”
26.5”
Crew Cab Long Bed Dually
168”
26.5”
2012-2013 CHEVY/GMC 6.6L DURAMAX LML
Vehicle Configuration
Wheel
Base
2012
Measure behind DPF to the back of the
vehicle. Cut Exhaust pipe at Cut line.
See Figure 2.
Extend Cab Standard Bed
144”
7”
Extend Cab Long Bed
158”
18”
Crew Cab Short Bed
153”
12”
Crew Cab Long Bed
168”
26.5”
Table 1