Banks Power 2011 Chevy_GMC 6.6L LML Duramax ECSB, ECLB, CCSB & CCLB including Dually models Turbo-Diesel Pickups User Manual
Page 8
12.
Figure 4 illustrates the proper
location of an exhaust clamp on a
tubing joint. Torque the nuts on each
of the exhaust clamps to 35 ft-lb.
NOTE: The clamps only need to be tight
enough to form a seal and hold the pipes
together. Over tightening the clamps
may cause the system to leak due to the
pipe being crimped.
13.
Remove the protective covering
from the tailpipe tip.
CAUTION: The protective covering
may ignite and burn if not removed
prior to running the engine.
14.
Your system includes two (2)
Banks Power decals designed to
complement the Duramax emblems on
the vehicle’s front doors.
15.
Re-connect the negative battery
cable. Start the engine and listen for
exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack weld slip connections
to prevent disengagement is
recommended. The Banks Monster
Exhaust installation is now complete.
Gale Banks Engineering
546 Duggan Avenue • Azusa, CA 91702
(626) 969-9600 • Fax (626) 334-1743
Product Information & Sales: (888) 635-4565
Customer Support: (888) 839-5600
Installation Support: (888) 839-2700
bankspower.com
Figure 5