Snap-On Motorized Loader - Manual (Page 37)

3-10
Setup and Programming
4. Press ENTER to clear the last memory location. The
number of total memory locations decrements by one.
Pushing ENTER repeatedly continues to clear readings
from the top of the list down.
5. Press left DIGIT to select "None."
6. Press ENTER to return to RECALL mode.
7. Press ENTER again to return to measurements mode.
Clear Single Memory Location
Use the procedure in this section to clear a single memory
location.
1. Press RECALL DATA.
— The LCD display reads as shown in Figure 3-5. The
present memory location at the upper left, total
number of memory locations to the right and time
data was stored at far right.
— The LED display shows the measurement value of
that memory location while the LCD displays its
engineering units at the lower right.
2. Press up or down VALUE to select the particular memory
location to clear.
3. Press MANUAL CLEAR. The LCD display shows
"CLEAR" and the present (left) and total (right) memory
locations on the upper line, as shown in Figure 3-6.
4. Press right DIGIT to select "Single" on the lower LCD
line.
5. Press ENTER to clear the present memory location. The
number of total memory locations decrements by one
and all subsequent measurements move down one
location.
Push ENTER repeatedly to continually clear
readings until all subsequent and then prior
locations clear.
6. Press left DIGIT to select "None."
7. Press ENTER to return to RECALL mode.
8. Press ENTER again to return to measurements mode.