Speedhut Ford GT Series Gauge - Manual (Page 3)

Installation of your NEW Speedhut GT gauges.
10. Your Speedhut dash cluster arrives with all the gauges installed. There are a couple differences between
the factory dash and your new gauges that will be explained below.
11. Remove and install your LCD displays on the new dash insert. Be careful not to over tighten.
12. The new speedhut gauges utilize AC voltage to light up the dial backgrounds. Included in the kit is a
small black box with wires. This small black
box converts the DC voltage to AC voltage
which then feeds into each gauge to light
up the dial background. The pointer light-
ing receives its power from the main power
plug.
We have found the most convenient place
to locate this small black box is on the back
of the tachometer case using 3M double
stick tape. The inverter can then be spliced
into the temperature gauge wiring to
receive +12Volts (white wire) and ground
(black wire)
Use included splices to make the connec-
tions. See pictures below.
Black box Water temp gauge
white wire
black wire