Cobalt Digital COMPASS 9067 Upconverter - Manual (Page 31)

9067-OM (V4.4) 9067 PRODUCT MANUAL 2-5
Installation and Setup
Installing a Rear I/O Module
9067 Rear I/O Modules
Table 2-1 shows and describes the full assortment of Rear I/O Modules
specifically for use with the 9067.
Notes: • Rear I/O Modules equipped with 3-wire Phoenix connectors are supplied
with removable screw terminal block adapters. For clarity, the adapters are
omitted in the drawings below.
Table 2-1 9067 Rear I/O Modules
9067 Rear I/O Module Description
RM20-9067-A Provides the following connections:
• HD/SD-SDI coaxial input (SDI IN)
• Four reclocked SDI input copies (RCK OUT 1- 4)
• Four buffered SDI coaxial outputs (SDI OUT 1- 4)
RM20-9067-B Provides the following connections:
• HD/SD-SDI coaxial input (SDI IN)
• Four reclocked SDI input copies (RCK OUT 1- 4)
• Four buffered SDI coaxial outputs (SDI OUT 1- 4)
• RS-485 metadata output (RS-485)
Note: On card with +LTC option, this connector
provides RS-485 LTC I/O as well as Dolby
metadata output (selectable using card
control).