TC Electronic TouchMonitor - Manual (Page 17)

EN-17 Manual | TouchMonitor 7“/9“ Series common Getting Started | System Start-up
EN
Getting Started
System Start-up
Before connecting the TouchMonitor to the power supply, please
make sure, that the following connections are made according to
your unit (TM7, TMR7, TM9) and to your individual needs:
• Analog and/or digital audio input signals (depending on the hard-
ware confi guration of your unit)
• Digital outputs (if available)
• Optional external standard 16 : 9 VGA monitor
• Optional USB mouse
• LAN/Ethernet (if needed)
• Power supply
When the TouchMonitor is connected to the power supply, it will ini-
tiate its system startup sequence. After the boot-up the unit is ready
for use.
We assume that you are starting your TouchMonitor for the fi rst time.
You now should make some global settings to adopt the unit to your
audio system. After this short procedure you can create your fi rst pre-
set to work with.
NOTE - The fi gures in the following paragraphs may show so-
me options that are not available on your unit. The scope of available
options depends on model (TM7, TMR7, TM9), hardware confi gurati-
on, and activated licences.