TC Electronic XO24 - Manual (Page 16)

14
SETUPS
Dual Source Mono - Dual Zone
Using the Digital Input
• Digital Input 44.1 or 48kHz must be
present in the Digital Input.
• Press and hold the DIGITAL IN button
on the front panel until digital lock is
achieved.
Note: The signal present on the DIGITAL
INPUT is passed unprocessed to the
DIGITAL THRU connection on the rear
panel for further downstream processing.
This setup is used where two different
zones or rooms need to be covered. In this
case Stereo is not the object.
• Source 1 is connected to Input A and Source
2 to Input B.
• Configure the Routing section as illustrated
below.
• Set Crossovers and additional parameters.
Configuration overview
XO24 US_3101.qxd 31-01-2005 10:59 Page 14