TC Electronic XO24 - Manual (Page 20)

18
FRONT PANEL OPERATION
Parametric EQ (Speaker EQ)
Delay Line
Delay for each speaker Line. Especially for
compensating for speaker placement.
Range: 0 to 200ms
Limiter
A Limiter for each speaker line is available.
Correctly set the Limiter will prevent peaks from
damaging your speakers.
Threshold
Range: -40 to 0 dB
Sets the Threshold/activation point for the
Limiter.
EQ 1-4 Type: Gain Freq: Width/Slope:
Band 1 Hi Pass ±18 dB 20 Hz – 20 kHz 2nd order
Par EQ ±18 dB 20 Hz – 20 kHz 0,03 – 4 Oct
Band 2 Par EQ ±18 dB 20 Hz – 20 kHz 0,03 – 4 Oct
Band 3 Par EQ ±18 dB 20 Hz – 20 kHz 0,03 – 4 Oct
Band 4 Lo Pass ±18 dB 20 Hz – 20 kHz 2nd order
Par EQ ±18 dB 20 Hz – 20 kHz 0,03 – 4 Oct
Ratio
Range: Off to Infinity
Sets the amount of attenuation.
Attack
Range: 1 to 100ms
The Attack time is the time it takes for the
Limiter to reach the gain-reduction specified by
the Ratio parameter.
Release
Range: 100ms to 7 sec.
Sets the time it will take for the Limiter to
release the attenuation of the signal.
Output
Range: 6; 12; 18; 22dBu
It is important that the Controller Outputs are
correctly matched to the Input range of your
amplifier. Please refer to your amplifiers manual
for correct settings.
or
or
XO24 US_3101.qxd 31-01-2005 11:00 Page 18