Rainbow Electronics AT25DF041A - Manual (Page 32)

32
3668E–DFLASH–11/2012
AT25DF041A
Notes: 1. Not 100% tested (value guaranteed by design and characterization).
2. 15 pF load at 70 MHz, 30 pF load at 66 MHz.
3. Only applicable as a constraint for the Write Status Register command when SPRL = 1
12.4 AC Characteristics
Symbol Parameter
AT25DF041A
(2.3V version) AT25DF041A
Min Max Min Max Units
f
SCK
Serial Clock (SCK) Frequency 50 70 MHz
f
RDLF
SCK Frequency for Read Array (Low Frequency - 03h opcode) 33 33 MHz
t
SCKH
SCK High Time 8.0 6.4 ns
t
SCKL
SCK Low Time 8.0 6.4 ns
t
SCKR
(1) SCK Rise Time, Peak-to-Peak (Slew Rate) 0.1 0.1 V/ns
t
SCKF
(1) SCK Fall Time, Peak-to-Peak (Slew Rate) 0.1 0.1 V/ns
t
CSH
Chip Select High Time 50 50 ns
t
CSLS
Chip Select Low Setup Time (relative to SCK) 5 5 ns
t
CSLH
Chip Select Low Hold Time (relative to SCK) 5 5 ns
t
CSHS
Chip Select High Setup Time (relative to SCK) 5 5 ns
t
CSHH
Chip Select High Hold Time (relative to SCK) 5 5 ns
t
DS
Data In Setup Time 2 2 ns
t
DH
Data In Hold Time 3 3 ns
t
DIS
(1) Output Disable Time 7 6 ns
t
V
(2) Output Valid Time 7 6 ns
t
OH
Output Hold Time 0 0 ns
t
HLS
HOLD Low Setup Time (relative to SCK) 5 5 ns
t
HLH
HOLD Low Hold Time (relative to SCK) 5 5 ns
t
HHS
HOLD High Setup Time (relative to SCK) 5 5 ns
t
HHH
HOLD High Hold Time (relative to SCK) 5 5 ns
t
HLQZ
(1) HOLD Low to Output High-Z 7 6 ns
t
HHQX
(1) HOLD High to Output Low-Z 7 6 ns
t
WPS
(1)(3) Write Protect Setup Time 20 20 ns
t
WPH
(1)(3) Write Protect Hold Time 100 100 ns
t
SECP
(1) Sector Protect Time (from Chip Select High) 20 20 ns
t
SECUP
(1) Sector Unprotect Time (from Chip Select High) 20 20 ns
t
EDPD
(1) Chip Select High to Deep Power-down 3 3 µs
t
RDPD
(1) Chip Select High to Standby Mode 3 3 µs