Rainbow Electronics 900 - Manual (Page 158)

FLYFOT-M260-MODULE
Page: 158 / 239
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
16.3 Service reporting control +CR
16.3.1 Description :
This command enables a detailed type of service reporting in the case of incoming or outgoing data calls.
Before sending the CONNECT response to the application, the product will specify the type of data
connection that has been set up.
These report types are :
16.3.2 Syntax :
Command syntax : AT+CR=<mode>
Command
Possible responses
AT+CR=0
Note : Extended reports disabled OK
Note : Command valid
AT+CR=1
Note : Extended reports enabled OK
Note : Command valid
AT+CR?
+CR: 1
OK
AT+CR=?
+CR: (0,1)
OK
16.3.3 Defined values:
<mode>:
0: disable extended reports
1: enable extended reports
16.4 Cellular result codes +CRC
16.4.1 Description :
This command allows more detailed ring information for an incoming call (voice or data). Instead of the
string “RING”, an extended string is used to indicate which type of call is ringing (e.g. +CRING: VOICE).
These extended indications are:
+CRING: ASYNC for asynchronous transparent
+CRING: REL ASYNC for asynchronous non-transparent
+CRING: VOICE for normal speech.
+CRING : FAX for fax calls
16.4.2 Syntax :
Command syntax : AT+CRC=<mode>