Yamaha DTXPRESS II - Manual (Page 26)

26
■ Connecting a Computer
The following two methods are available for connecting the
DTXPRESS II to a computer.
1. Directly connect the computer’s serial port to the
DTXPRESS II’s TO HOST jack.
2. Connect the DTXPRESS II’s MIDI IN jack to the com-
puter through a MIDI interface.
1. Directly connect the serial port to the TO HOST jack.
The method used for connect and transferring signals between a
computer and the DTXPRESS II is basically the same, no matter
what type of computer is used.
Getting More Out of Your DTXPRESS II
Use a cable to connect the devices and set the HOST SE-
LECT SWITCH according to the type of computer serial
port and clock used. Carefully read the instructions on
the right side of this page and select an appropriate cable
for the type of computer you are using.
The input signal from the TO HOST jack will be trans-
mitted to the DTXPRESS II’s tone generator and se-
quencer, and simultaneously transmitted to the
DTXPRESS II’s MIDI OUT jack. At this time, only
message for the port number that is set in the Utility
mode’s [3-10. Host Thru Port] (Reference Guide : P.
33) will be sent to the MIDI OUT jack.
The signal from the tone generator and sequencer is
merged with the signal from the MIDI IN jack and
output to the TO HOST jack.
2. Connect the MIDI IN Jack to a MIDI Interface
• If you are using a computer equipped with a MIDI interface,
connect the MIDI OUT jack on the computer to the MIDI IN
jack on the DTXPRESS II. Set the HOST SELECT switch to
the “MIDI” position.
• If you are using a Macintosh series computer with an external
MIDI interface, connect the MIDI interface to the computers
RS-422 jack (modem or printer port), connect the MIDI OUT
jack on the interface to the MIDI IN jack on the DTXPRESS
II. Set the HOST SELECT switch to the “MIDI’ position.
* When the HOST SELECT switch is set to the “MIDI” position, the
transmission and reception via the TO HOST jack is ignored.
Computer
Serial Port
Serial Cable
TO HOST
DTXPRESS II
Computer Connecting Cables
● Mac
Apple Macintosh Peripheral cable (M0197).
Maximum length 2 meters.
mini DIN 8-pin mini DIN 8-pin
2 (HSK i) 1
1 (HSK o) 2
5 (RxD _) 3
4 (GND) 4
3 (TxD _) 5
8 (RxD +) 6
7 (GP i) 7
6 (TxD +) 8
● PC-1
8-pin MINI DIN to D-SUB 25-pin cable.
If your PC-1 type computer has a 9-pin serial port, use the
PC-2 type cable. Maximum length 1.8 meters.
D-SUB 25-pin
mini DIN 8-pin
5 (CTS) 1
4 (RTS) 2
3 (RxD) 3
7 (GND) 4
8
2 (TxD) 5
● PC-2
8-pin MINI DIN to D-SUB 9-pin cable.
Maximum length 1.8 meters.
8 (CTS) 1
7 (RTS) 2
2 (RxD) 3
5 (GND) 4
8
3 (TxD) 5
mini DIN 8-pin
D-SUB 9-pin
If you are using a computer equipped with a USB port,
you can connect the DTXPRESS II to your computer via
a USB-MIDI interface such as the YAMAHA UX16/96/
256, etc.