Yamaha CLP-970A User Manual
Page 88
88
CLP-970A
Message
Meaning
You tried to perform another operation before saving the recorded song to
storage memory. If you continue the operation, the recorded song will be
lost. To delete the new recording, press the B [– (NO)] button. To keep the
recording, press the B [+ (YES)] button. The Clavinova displays the
“SaveToMemory” (page 50) parameter screen. Save the recorded song, then
proceed to another operation.
The Clavinova has found some defects in the selected (or playing) song.
Select the song and play it again. If you still see this message, the song data
may be damaged.
The Current memory space is full during recording. Recording stops automat-
ically. The data recorded up to that point remains. This message also appears
when you try to enter recording mode to make an additional recording but the
song data already fills the Current memory. In this case, you cannot make an
additional recording. Use the “ChannelClear” parameter (page 69) to delete
unnecessary tracks (if any) to make more room in memory.
This message prompts you to start the operation. To start, press the B [+
(YES)] button. Press the [EXIT] button to cancel the operation.
This message prompts you to confirm the execution. Press the B [+ (YES)]
button to continue. Press the B [– (NO)] button to cancel.
There is a malfunction with the TO HOST connector.
When you are using the CLP-970A with a connected computer:
The power to the computer is turned off, the cables are connected incor-
rectly, the [HOST SELECT] switch is set incorrectly, or the driver or MIDI
application on the computer works incorrectly. Turn off the power to the
CLP-970A and the computer, then check the cable connections and the
[HOST SELECT] switch setting. Then, turn on the power to the computer
and the CLP-970A in this order and check to see if the driver and MIDI
application on the computer work properly.
When you are using only the CLP-970A:
This message appears if a cable is connected to the TO HOST connector on
the CLP-970A. In this case, turn off the power to the CLP-970A, remove the
cable from the TO HOST connector, then turn on the power to the CLP-
970A. If the cable is left connected to the TO HOST connector, the CLP-
970A may not work correctly.
You used a period or space at the beginning of a song name or you tried to
change a song name that includes a character (or characters) not supported by
the CLP-970A, and the CLP-970A could not process the name. The Clavinova
displays the previous screen in three seconds. Rename the song correctly.