Yamaha CLP-970A - Manual (Page 97)

CLP-970A
97
CLP-970A/970AM/970AC: Keyboard Stand Assembly
3.
Mount the main unit.
4.
Fix the main unit.
5.
Connect the pedal cord.
6.
Secure the pedal cord.
7.
Set the voltage selector and connect
the power cord.
CAUTION
• Fingers can become pinched between the main
unit and the rear or side panels, be extra careful
so as not to drop the main unit.
• Do not hold the keyboard in any position other
than the position shown in the above illustration.
Be sure to place your hands at least
10 centimeters from either end of the
main unit when positioning it.
at least
10 cm
(2) Use short flat-head screws 2 to
secure the main unit from the
front.
* Use the rear hole on the front
brackets to attach the screws.
(1) Center the main unit to produce equal clearance
on the left and right sides.
(1) Pass the pedal cord plug
from the rear as shown,
and insert the plug into the
PEDAL jack.
(2) Use a vinyl tie to
take up any slack in
the pedal cord.
(1) Attach the cord
holders to the rear
panel as shown, then
clip the cord into the
holders.
Voltage Selector
Before connecting the
AC power cord, check
the setting of the
voltage selector which
is provided in some
areas. To set the
selector for 110V, 127V,
220V or 240V main
voltages, use a “minus”
screwdriver to rotate the selector dial so that the correct
voltage for your region appears next to the pointer on the
panel. The voltage selector is set at 240V when the unit is
initially shipped.
After the proper voltage has been selected, connect the AC
power cord to the AC INLET and an AC wall outlet. A plug
adaptor may be also provided in some areas to match the
pin configuration of the AC wall outlets in your area.
CAUTION
• An improper voltage setting can cause serious damage
to the Clavinova or result in improper operation.