Yamaha CLP-970A - Manual (Page 73)

CLP-970A
73
Detailed settings for the voices [VOICE SETTING]
In Dual mode:
Setting range:
0 - 127
You can specify the position in the stereo image from
which you hear the sound.
See the procedure on page 66.
In Dual mode:
Setting range:
L64 (hard left) - C (center) - R63 (hard right)
You can slightly shift the pitch of two voices selected
for Dual mode.
See the procedure on page 66.
Setting range:
–20 - +20 (With positive values, the pitch of Voice 1 is
raised and the pitch of Voice 2 is lowered. With nega-
tive values, the pitch of Voice 1 is lowered and the pitch
of Voice 2 is raised.)
You cannot set this parameter for the voice parts “Left” and
“LeftXLayer.”
See the procedure on page 66.
Setting range:
Room Simulates reverberation in a room.
Hall
Simulates reverberation in a concert hall.
Hall2 Reverberation is slightly longer than that of
“Hall1.”
Stage Reverberation suitable for a solo instrument
sound.
Plate Reverberation from the vibration of a metal
plate.
The reverb effect is not applied if the ReverbSend parameter
is set to “0.”
See the procedure on page 66.
Setting the position of right and
left channels [Pan]*
Fine tuning the pitch (only in
Dual mode) [Detune]
A B
C D
NO YES
Voice for editing (Voice 1 and Voice 2)
A B
C D
NO YES
A B
C D
NO YES
Voice for editing (Voice 1 or Voice 2)
A B
C D
NO YES
Selecting the reverb type
[ReverbType]
Setting the reverb depth
[ReverbSend]*
TIP
A B
C D
NO YES
TIP
A B
C D
NO YES