American Car Craft Camaro Valve Cover_Coil Pack Cover Set Polished ZL1 Only 2012-2013 - Manual (Page 3)

serve as a completely adequate auxiliary ground location. Simply remove that bolt and then attach the ground
and tighten securely.
7. With the electrical harnesses secured at this high location the coil pack leads should be set to come down just
above each coil pack location. This will set things up so that they look good leading to the coil packs providing a
real nice clean detailed and professional look.
Fig.1
8. Moving over to the driver side you will perform much of the same procedure only on this side you will be
relocating the brake booster vacuum cable as well as an addition but much thinner vacuum line. Neither one of
these vacuum lines need to be extended however they both will need to be relocated up high on the rails and
that the brake booster vacuum hose is manipulated around the A/C line. This will set things up so that they have
plenty of clearance for the new cover without any possibility of chafing any line. It is very important that you
consider all harnesses and hoses to have adequate slack for engine movement as well as a free leading set up
meaning no kinks or strain to any wires and or hoses. At first this may seem unattainable but however if you
take a few minutes to analyze the location and routing of these elements you find that you will be able to
rearrange things perfectly without sacrificing or threatening any of these elements. The end result should leave
you with all four coil pack connectors nicely aligned to their proper locations. At this time install the factory
engine shroud to make sure all of the elements have been successfully tucked under the cover removing them
from plain view and that the cover itself will snap in place properly. You should see only the four coil pack
electrical leads hanging down from the bottom of the factory engine shroud at this point of the installation.
9. Now that you have successfully performed the wire tuck procedure you can move on to installing your new
covers. These all stainless covers have been designed to bolt directly to the factory coil pack mount locations.
We have supplied you with a pair of large plastic gloves. This is to allow you to remove the protective liner of the