American Car Craft Camaro Valve Cover_Coil Pack Cover Set Polished ZL1 Only 2012-2013 User Manual
Page 4
new covers at this point and handle their installation without fudging them up with finger prints as you insert
them. Starting on the passenger side set the new cover into position and align the round holes of the new
cover with the coil pack mounting hole locations. NOTE: The cover has been designed to fit closely around the oil
fill neck so you will need to force a small part of the new cover into this location. Once you have lined everything
up simply set each coil pack in place and then remove the protective liners and set the stainless coil pack covers
over each pack and then loosely insert each of the eight factory bolts. Do not tighten any of these bolts as this
will cause you to bind. Set each bolt in place then once they are all in place you can proceed to tighten them.
You have been provided with eight chrome bolt caps. Simply tap on each cap to finish the passenger side kit
installation and then snap on all four coil pack electrical connections. Repeat this exact installation for the driver
side and make sure there is no obstruction of any wires hoses before you permanently install this side…
especially the brake booster vacuum line and or any other lines or wires.
10. Images of the valve cover kit both driver and passenger sides
American Car Craft LLC
18924 Sakera Rd Hudson, FL. 34667
Ph 727.861.1500 Fax 727.861.1520