Peterson Sonuus Wahoo - Manual (Page 12)

12 © Copyright 2012 Sonuus Limited Wahoo
Owner’s Manual
Creating your own presets
You can create and store up to 100 user presets on the Wahoo. The steps for creating a preset are
straight-forward.
Creating and saving a user preset Creating and saving a user preset Creating and saving a user preset Creating and saving a user preset
Ensure that the LOCK switch is in the unlocked position. Starting from any preset (factory or
user), adjust the Wahoo settings using the LEVEL , FILTER and MODE knobs to get the desired
musical effect. These settings are discussed in detail later.
Save the preset. Press the save button. Use the S S S ST T T T buttons to select a user preset
number ( P00–P99) where you would like to store your preset. The name of the existing
preset (if any) flashes alternately with the preset number to help you select either an
unused preset or a preset to overwrite. Press the save button again when you have
selected your preset number. You can now edit the three-character preset name. Using any
one of the three knobs ( LEVEL , FILTER or MODE ) turn the knob to cycle through A-Z, 0-9 and
press a knob to advance to the next of the three characters in the preset name. Finally,
press the save button to write your preset to the chosen location.
The save button flashes while this save process is in progress. To abandon the save at any
time, and revert to Preset Select mode, press and hold the save button for 2 seconds.
Selecting and changing parameters Selecting and changing parameters Selecting and changing parameters Selecting and changing parameters
When you press the FILTER button, or press or move a knob ( LEVEL , FILTER or MODE ), the
Wahoo will enter Preset Edit mode. The flashing LED shows which parameter is being
displayed on the numeric display. Pressing a knob will let you select another parameter to
be edited. For example, successive presses on the LEVEL knob will cycle between editing
drive, filt mix 1/2, dry/wet and output.
Change the value of a parameter by turning the knob next the that parameter’s LED . When
you have the value that you want for that parameter, select another parameter to edit.
When you have completed your editing, you can save your setup as described previously.
Some parameters have sub-parameters. For these, the S S S ST T T T buttons will also flash. Cycle
round the sub-parameters using the S S S ST T T T buttons. The name of the sub-parameters is
shown on the display to make it clear what is being selected for editing. Turn the knob to
change the value of the sub-parameter that is being edited.
All of the filter parameters and the mode parameters can be set independently for each of
the two filters. Select which filter to edit by using the FILTER button to switch between filter 1
and filter 2. The filter whose settings are being altered is indicated by the illuminated filter
LED ( 1 or 2).