Peterson Sonuus Wahoo - Manual (Page 18)

18 © Copyright 2012 Sonuus Limited Wahoo
Owner’s Manual
Adjusting
MODE
The MODE controls of the Wahoo work slightly differently from the LEVEL and FILTER controls
described above. Each of the two filters has one mode, selected from pedal, LFO , envelope or pitch,
and the mode for each filter can be different. Configure each filter separately, switching between
them using the
FILTER button. For each filter, press the MODE knob to cycle through the modes,
stopping on the operating mode you want for this filter. Use the S S S ST T T T buttons to cycle through the
sub-parameters for this mode and turn the MODE knob to change the values of the sub-parameters.
You do not need to set up values for the sub-parameters of the other modes for this filter—you only
set up the single mode that you have selected for this filter.
When both filters are in the same mode they can work together to create thick, vocal tones. When
the filters are in different modes you can get new interesting effects.
Note: the custom parameters are covered later in this manual (see “Custom settings” on page 27).
They operate separately from the four modes described above.
Pedal mode
If you select pedal mode for a filter, you can select standard wah pedal operation or
MIDI
-controlled
operation by setting the value of the pedal parameter as described in the following table. For details
on MIDI operation, refer to “ MIDI operation” on page 25.
Pedal parameter value Description
PEd pedal: The Wahoo footpedal controls the filter: standard wah pedal mode.
CtL control: MIDI expression controller (14-bit) controls the filter.
rEM remote: MIDI cut-off and resonance controllers (7-bit) control the filter.
not note: MIDI note controls the filter.