PowerWalker ViewPowerMini - Manual (Page 47)

46
5.2.3. Parameter Setting
Some UPS functions can be set and changed via software. Parameter setting includes
backup time setting for P1, battery number setting, voltage and frequency range
setting for bypass mode, and voltage range setting for ECO mode.
Step 1 Select UPS Setting >> Parameter Setting. Refer to Diagram 5­16.
Diagram 5­16
NOTE: This screen may be different for different types of UPSs.
Step 2 Select the functions by clicking “Enable” or “Disable” button. Or change the
numbers by clicking up­down arrows or modify the numbers directly in the
number column.
Step 3 Click “Apply” button to save the settings. Each function setting is saved by
clicking each “Apply” button.
NOTE1: Any functions which are not supported by UPS will not be able to access.
NOTE2: Click “Default” button to recover the default setting.
l Alarm Control: If enabled, UPS alarm will be activated. Vice versa.
l Alarm at bypass mode: If enabled, UPS alarms when it’s working at bypass
mode. Vice versa.