Peerless-AV WSP724-W - Installation - Manual (Page 2)

ISSUED: 11-14-06 SHEET #: 024-9010-1
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
2 of 4
Wall plate (A) can be mounted to three studs that are 16" apart on center for WSP 716 models and 16",
20" or 24" on center for WSP 724 models.
Use a stud finder to locate the edges of the studs. Use of an
edge-to-edge stud finder is highly recommended.
Based on their edges, draw a vertical line down each stud’s center. Place wall plate on wall as a
template. Level plate, and mark the center of the twelve mounting holes. Make sure that the mounting
holes are on the stud centerlines. Drill twelve 1/2" holes through drywall and metal studs.
Note: It may be
necessary to drill 5/32" pilot holes prior to drilling 1/2" holes.
• Product must be mounted through drywall that has a
minimum thickness of 1/2" and into metal studs, 26
gauge or heavier.
• Make sure that togglers are anchored into the center
of the studs as shown in figure 1. The use of an "edge
to edge" stud finder is highly recommended.
WARNING
A
figure 1