Knape&Vogt BYP-60AFS3 Series - Manual (Page 2)

Hmax = Door Height + 2-1/16" • Hmin = Door Height + 1-5/8"
3/8" - 1/2"
(1 cm - 1,3 cm)
1-1/4" - 1-9/16"
(3,2 cm - 4 cm)
3-1/2"
(8,9 cm)
1
2
PREPARE OPENING
MOuNt FRAME HARDWARE
• Center track in opening.
• Using track as template, mark
screw locations.
• Drill 3/32" pilot holes and secure
with (#8 x 1-1/4") screws.
(F)
Note: If necessary, track may be
cut with a fine tooth saw.
2-Door Width = 2 x Door Width - 1"
3-Door Width = 3 x Door Width - 2"
SLIDING DOOR HARDWARE - BY PASS
Assembly
Instructions
#310299_C (1013)
3
MOuNt DOOR HARDWARE
• Place carriers on back of each
door at the distance shown.
• Using carriers as a template,
drill 3/32" holes and secure
with (#8 x 3/4") screws.
(E)
• Drill 2-1/8" diameter hole
approximately 1/4" deep
on outside edge of each
door as shown to mount pulls.
2" (5,1 cm)
36"
(91,4 cm)
Opening Height
Hauteur Ouverture
Altura Abertura
Door Height
Hauteur Porte
Altura Puerta
Left Edge
Bord gauche
Borde izquierdo
Right Edge
Bord droit
Borde derecho
1-3/16"
(3 cm)
1/2"
(1,3 cm)