Braun 7680 SyncroPro System - Manual (Page 7)

7
Display
The pilot light shows that the shaver is connected to an
electrical outlet.
The display shows the operation mode and charging
status of the shaver: During charging, the display shows
the battery capacity symbol increasing by 20%
segments and the charging time remaining (flashing):
First charging (4 h):
The display counts down in 20 min. steps.
Subsequent chargings (1 h):
The display counts down in 5 min. steps.
The batteries are fully charged. SmartLogic monitors the
batteries and communicates «Test...ok» when it is still
well charged. Below 10 minutes remaining shaving time,
the display shows the minutes left.
The «moving» plug symbol indicates that you should
charge your shaver. If there is insufficient battery
charge for a cordless shave, either recharge the shaver
or shave via the power supply cord connected to the
mains.
* The display changes to this format when the shaver is in
the Clean&Renew™.
The SmartLogic inside your shaver automatically
monitors the condition of the batteries as well as the
charging / discharging processes and adapts them to
your personal shaving patterns. For instance, if it is your
routine to never let the batteries run low, the SmartLogic
will recognize this, look for a pause when you are likely
to not use the shaver, completely discharge and then
recharge your shaver to recondition the batteries (every
six months at the most, and only when necessary).
For additional information, press the info key:
press once:
– to display the duration of the last shave
press again:
– to display the key part number for shaver foil and
cutter block
hold for 3 secs:
– to run a display demo
7680
*
*
5491311_S 4-38 Seite 7 Donnerstag, 27. Oktober 2005 3:13 15