Braun 7680 SyncroPro System - Manual (Page 8)

8
The SmartLogic inside your shaver will detect when the
shaver needs to be cleaned (refer to paragraph «Manual
cleaning» or to section B). To reset the display, push the
info key.
The SmartLogic inside will recognize when the shaver
has to be lubricated (refer to paragraph «Manual
cleaning» or to section B). To reset the display, push
the info key.
The shaver cannot be charged if the environmental
temperature is too low (<32 °F/0 °C) or too high
(>130 °F/55 °C).
Allow the shaver to remain for some time at room
temperature for optimal charging conditions.
No display: The rechargeable battery is completely
discharged and has to be recharged.
Shaving
Switch positions
0 = Off (switch is locked)
Press and push up the switch to operate the shaver:
1 = Shaving with the pivoting head
The pivoting cutting system automatically adjusts
to every contour of your face.
2 = Shaving with the pivoting head locked at an angle
(to permit shaving in difficult areas, e.g. under the
nose).
3 = The long hair trimmer is activated
(for trimming sideburns, moustache and beard).
Shaving with the cord
If the rechargeable battery is discharged, you may also
shave with the shaver connected to an electrical outlet
via the special cord set.
(If the shaver does not run immediately, charge it with the
switch on position «0» for approx. 1 minute.)
Tips for the perfect shave
• It can take up to 14-21 days for your beard to adjust to
the new shaving system.
• Shave before washing your face or taking a shower, as
skin tends to swell after washing.
• The drier the skin, the closer the shaving results will be.
• Hold the shaver at right angles (90°) to the skin. Stretch
your skin and shave against the direction of beard
growth.
• To maintain 100% shaving performance replace your
foil and cutterblock every 18 months or when worn.
21
2
a u to
m
a ti c lo
c k
2
1
3
1
5491311_S 4-38 Seite 8 Donnerstag, 27. Oktober 2005 3:13 15