Sena Bluetooth SR10 v1.2 User's Guide - Manual (Page 18)

English
19
6.6 Reset to Factory Default Settings
1. To restore the SR10 to factory default settings, press and hold
the Pairing Button for 12 seconds until the LED shows solid
red.
2. Within 5 seconds, press the Pairing Button again to confirm
reset. The SR10 will be restored to factory settings and
switched off automatically after the blue LED flashes several
times.
3. If you don't press the Pairing Button within 5 seconds, the reset
attempt is canceled and the SR10 returns to standby mode.
6.7 Fault Reset
If the SR10 is not working properly or is in a faulty status for any
reason, you may reset by pushing the small reset button at the
top of the SR10 main unit. By using a paper clip or a pencil tip,
lightly press and hold the reset button for 1 second. The SR10 will
be switched off. Turn the SR10 back on to use it. However, this will
not restore the SR10 to factory default settings.
6.8 Firmware Upgrade
The SR10 supports firmware upgrade function. Please visit Sena
Bluetooth web site at www.senabluetooth.com to check the
latest software downloads.