Crown Audio IQ-P.I.P.-MEM - Manual (Page 33)

Page 33 Reference Manual
IQ–P.I.P.-MEM Programmable Input Processor for IQ Systems
7 IQ Address Tables
This section contains lookup tables for
every valid IQ address. The valid
addresses are 1 to 250. Remember
that address “0” (zero) will put the IQ–
P.I.P.-MEM into a stand-alone mode
where it is invisible to the IQ System
and acts like a “dumb” balanced
audio input. Do not use an address
number higher than 250! Addresses
above 250 are reserved for special
system use.
Remember: No two IQ components
of the same type which are
connected to the same Crown Bus
loop can have the same address.
To use the IQ address tables, simply
find the address you want and set the
IQ address switch of the IQ–P.I.P.-
MEM as shown. See Section 4.1 also.
Fig. 7.1 IQ Address Switch (SW1) Settings from 0 to 125