Anchor Audio AN-MINI_MiniVox Lite - Manual (Page 4)

MADE IN USA
SIX YEAR WARRANTY
AN-Mini/MiniVox Lite Owners Manual
For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com
USING YOUR WIRELESS MICROPhONES
After you have set the transmitter channel (see above) you are ready to use your wireless microphone:
1. Body-pack transmitter users must insert
the mic plug into the transmitter jack marked
MIC
2. Push the transmitter power button for two sec-
onds until ON (The red LED will stay on when
the mic is turned on. If the red LED flashes, the
battery is low)
3. Turn the AN-Mini power switch to ON
4. The RX indicators will light
(only one indicator
will light at a time) when the wireless signal is
being transmitted and received
OPERATING ThE WIRELESS MICROPhONE/TRANSMITTER
4
CAUTION: harmful feedback may occur when walking in front of a sound system or speaker with a wireless microphone. Always point microphone away from speakers!
ChANNEL SELECTION - hANDhELD TRANSMITTER
1. Unscrew battery cover on bottom of microphone
2. Set the CHANNEL SELECTOR dial to match the channel setting
of your receiver
3. Replace battery cover and tighten firmly
NOTE: When using dual wireless, each microphone must be set to a different channel!
ChANNEL SELECTION - BODY-PACK TRANSMITTER
1. The channel selection dial is located on the side of the transmitter
2. Set the CHANNEL selection dial to match the channel setting of the receiver
Waste electrical and electronic products must not be disposed
of with household waste. Please recycle where facilities exist.
Check with your Local Authority or Retailer for recycling advice.