Buyers 1801005 - Manual (Page 11)

Quality since 1946 Quality since 1946
11
4. Tighten nuts in the following order: First
torque 3/8" nuts to 40 ft-lb. Then torque 1/2" nuts
to 70 ft-lb.
5. Install plastic plugs into 3/8" holes in
middle section.
Toyota Tundra, 2000-2006
1 3004980 1 Middle Section
2 3004908 1 Side Bracket
3 3004909 1 Side Bracket
4 FCS038016125 8 Screw, HHC-3/8-16 x 1.25 Gr 5 Zn
5 FWF038081006 16 Washer, Flat 3/8 SAE Zn
6 FNE038016044 8 Nut, Nylock 3/8-16 x 7/16 Zn
7 3004907 4 Bolt Plate, 1/4"
8 3001384 4 Screw, Hex Cap 1/2-13 x 2" Gr 5 Zn
9 FWF050106010 4 Washer, Flat 1/2" SAE Zn
10 FNE050013053 4 Nut, Nylock 1/2-13 Zn
11 3005078 2 Plug, 7/16" dia. Poly
ITEM PART NO. QTY. DESCRIPTION
Bill of Materials
Tools Required
•1/2" drill bit
•3/4" socket
•3/4" wrench
•15/16" socket
•15/16" wrench
•21 mm socket
•Torque wrench
1. Use existing holes at rear of frame and install
1/2" screws through 1/4" plates and into frame.
With 1/2" screws, washers and lock nuts attach
brackets to frame. Do not install fasteners in the
forward holes in brackets at this time.
2. Install middle section as shown. Use bolting
locations indicated. Attach middle section using
3/8" screws, washers and lock nuts.
NOTE: Be
sure to use four holes to bolt side brackets to
middle section.
3. Using forward most holes in brackets as a
guide, drill 1/2" holes and install 1/2" screws with
1/4" plates through frame and brackets. Then
install 1/2" washers and lock nuts.