2 connecting to the network – SENA LS100 User Manual
Page 11
Advertising
11
Figure 2-2 Connecting the power to the LS100
2.2.2 Connecting To The Network
Connect the one end of the Ethernet cable to the LS100 10Base-T port and the other to the Ethernet
network. If the cable is properly hooked up, the LS100 will have a valid connection to the Ethernet
network by indicating:
- [Link] lamp of the LS100 maintains solid green
- [Act] lamp continuously blinks to indicate the incoming/outgoing Ethernet packets
If any of the above does not happen, the LS100 is not properly connected to the Ethernet network.
Figure 2-3 Connecting a network cable to the LS100
Advertising