SENA LS100 - Manual (Page 20)

20
2.4.4 ‘factorydefault’ Command
With ‘factorydefault’ command, users can load factory default parameter values in console. Command
usage of ‘factorydefault’ is as follows:
factorydefault [option] + <CR>
where,
- if option is omitted, all parameters are set with factory default values.
- if option='-ip', all parameters except IP settings are set with factory default values.
Loaded values are not saved until ‘save’ command invoked. After ‘factorydefault” command, ‘save’ and
‘reboot’ commands are required for changes to take effect.
> factorydefault (or factorydefault –ip)
OK
> save
OK
> reboot
Figure 2-17 Factory default reset screen
2.4.5 ‘save’ Command
With ‘save’ command, current parameter changes are saved to non-volatile memory. Command usage
of ‘save’ command is as follows:
save + <CR>
Saved changes will be applied if the LS100 is rebooted by ‘reboot’ command or manual rebooting.
2.4.6 ‘exit’ Command
With ‘exit’ command, current serial or remote console session will be closed. However, changed
parameters are not applied until the LS100 is manually rebooted. Command usage of ‘exit’ command
is as follows:
exit + <CR>