SENA LS100M-SK User Manual
Page 24
Advertising
24
2.4.6 ‘exit’Command
With ‘exit’ command, current serial or remote console session will be closed. However, changed
parameters are not applied until the LS100M is manually rebooted. Command usage of ‘exit’
command is as follows:
exit + <CR>
2.4.7 ‘reboot’Command
With ‘reboot’command, the LS100M will be rebooted immediately. Changed parameter values will be
applied when the LS100M is up again. Command usage of ‘reboot’is as follows:
reboot + <CR>
Advertising