SENA LS100M-SK - Manual (Page 9)

9
2: Getting Started
This chapter describes how to set up and configure the LS100M in the first place by using the test bed
included in the LS100M-SK.
- 2.1 Board layout and connectors explains the board layout for the LS100M and the test bed for it
and the connectors.
- 2.2 Connecting the Hardware describes how to connect the power, the network, and the serial
device to the LS100M.
- 2.3 Accessing Console Port describes how to access the console port using a serial console at a
local site or telnet console at a remote site.
- 2.4 Command Usages described how to use command set of the LS100M to configure and view
parameter values and status.
Following items are pre-required to get started.
- One DC power adapter (included in the LS100M-SK package).
- One serial console cable for configuration (included in the LS100M-SK package).
- One PC with Network Interface Card (hereafter, NIC) and/or on e RS232 serial port.
- Terminal emulation program running on the PC
- One Ethernet cable
2.1 Board layout and connectors
2.1.1 The LS100M module
The LS100M is a DIL(Dual-In-Line) package module for on-board installation. It provides the external
interface pins of JP1 and JP2 for power, switch, LED, UART and the RJ45 connector for Ethernet. The
pin-out of the LS100M is described in the Table 2-1.
Table 2-1 Pin-out for the LS100M external interface
Pin NO. JP1 JP2
1 GND Vcc
2 Reset(High Active) Console/Data switch
(High : Data,Low : Console)
3 N.C Serial DSR
4 N.C Serial CTS
5 LED ( Ethernet Link/Collision) Serial DTR
6 Ethernet Tx- Serial RTS
7 Ethernet Tx+ Serial Rx
8 Ethernet Rx+ Serial Tx
9 Ethernet Rx- Factory Reset switch(Low Active)
10 Vcc GND
11 LED (Ready) LED (Serial Tx)
12 LED (Ethernet Act) LED (Serial Rx)