Aqua-Pure AP-DWS1000 - Manual (Page 6)

5
Quick Connect Guide (Figure 1)
AP-DWS1000 Parts List (Figure 2)
1
Push in grey collet to release tubing.
2
Tubing is secured in.
Grey Collet
Tube
Push tubing straight in as far as it will go.
1
Pull tubing straight out.
2
To Attach Tubing To Release Tubing
This product is outfitted with user friendly ‘Push In’ connectors. Proper
use of the connectors is shown in the diagrams. It is most important
that the tubing selected for use with these connectors be of high
quality, exact size and roundness, and with no surface nicks or
scratches. If it is necessary to cut the tubing, use a plastic tubing cutter
or sharp razor knife. Make a clean square cut. Should a leak occur at a
‘Push-In’ connector, the cause is usually defective tubing.
To Fix: • Relieve pressure
• Release tubing
• Cut off at least 1/4” from end
• Reattach tubing
• Confirm connection is leak free
‘Push-In’ Tubing Connector
(Quick Connect Fittings)
6
9
13 12
4
1
10
2
7
3
5
3
1 69968-31 Self-piercing water valve
2 36897-82* 1/4" inlet yellow tubing (price per ft.)
3 55851-02 DW-80 & DW90 Cartridge Set
4 36897-62* 1/4" inlet blue tubing (price per ft.)
5 69888-42 Faucet
6 68841-31 Shroud
7 68871-01 Head
8 85-400201 UTC Shroud Mounting Pin (not shown)
9 68845-31 3/8" NPT x 1/4" tube elbow
10 68873-31 1/4" NPT adaptor x 1/4" tube
11 74-3230404 1/4" plug-in elbow
12 68870-33 Metering valve
13 69804-34 Metering valve screw (need 4 each)
* Must order minimum of 10 ft (3 m).