OSRAM OPTOTRONIC OT EASY 60 II - Manual (Page 8)

8
IV 2009
OT EASY 60 Installation
Connecting the inputs
Proceed as follows:
Step Task
1 Connect the 4p4c modular connector of the EASY signal line.
2 Strip the power cable, remove the insulation from the phase and neu-
tral wires and connect to the screw terminals.
3 Connect the line of the external pushbutton to the screw terminals, if
applicable.
4 Mount the cable strain relief: Use a rubber adapter and cable clamp
that are suitable for the power cable diameter; see figure.
5 Insulate the PE conductor, if necessary.
Ø (G) mm Cable strain relief
6 - 7.5
E
F
G
H
7.5 - 8.5
8.5 - 9
E Modular cable
F Rubber adapter for modular cable
G Power cable
H Cable clamps