Draw-Tite 1040300 CARGO CARRIER - ECONOMY User Manual

Item: description

Advertising
background image

ITEM:

DESCRIPTION:

1040300N REV D 3-21-11

PRINTED IN CHINA

1040300

CARGO CARRIER 60” X 20”

Cequent Performance Products, Inc.

Plymouth, MI 48170

CONSUMER: Keep instructions and read before each use.

FIGURE 1.

DO NOT EXCEED LOWER OF: WITH 2” SHANK 500 LB LOAD CAPACITY; WITH 1-1/4” SHANK 300LB LOAD CAPACITY –

VEHICLE OR HITCH MFR’S TONGUE WEIGHT RATING

FIGURE 2.

Hex Bolt, 1/4” x 3/4”

12

Carriage Bolt, 3/8” x 3.00”

3

Hex Bolt, 1/2” x 3”

1

Hex Lock Nut, 1/4”

12

Hex Lock Nut, 1/2”

1

Hex Nut, 3/8”

3

Flat Washer, 1/4”

24

Flat Washer, 1/2”

2

Flat Washer, 3/8”

3

Hitch Pin, 5/8”

1

Hitch Pin, 1/2”

1

Clip

2

End Plate

1

End Plate w/ Shank hole

1

Center Plate

1

Shank

1

Adaptor

1

Basket Frame

2

1.

Align both halves of the basket on the ground, attach each end plate to
the outside of the basket as shown in Fig 1 and fasten loosely with (12)
1/4” bolts, (24) 1/4” flat washers, and (12) 1/4” hex nuts.

2. Slide 2” shank through shank hole and align holes in

end plates. Align center plate on the inside of the
basket with holes in shank and loosely attach with
(3) 3/8” carriage bolts, (3) 3/8” flat washers, and (3)
3/8” nuts.

3. Go back and tighten all hardware. Tighten all 1/4” hex

bolts to 6 ft-lb and all 3/8” bolts to 24 ft-lb

1/4” flat washer,

1/4” hex nut (12

places)

1/4”x ¾” hex bolt,

1/4” flat washer (6 places)

End plate

w/ shank

hole

Center Plate

3/8” X 3.00” carriage bolt,

3/8” flat washer,

3/8” hex nut (3 places)

Shank

(1)

1/4”x ¾” hex bolt,

1/4” flat washer (6 places)

End plate

Advertising
This manual is related to the following products: