GE Industrial Solutions EntelliGuard G Key Interlock Kit - Manual (Page 4)

10.
To reinstall the cover, rotate the charging
handle down and slide the front cover over the
handle to assemble the front cover to housing as
shown in Fig. 6.
Figure 6.
11. Ensure the fascia is aligned properly with the
trip unit and the pad lock features of the breaker.
12
.
Fasten the 6 mounting screws of fascia with
the housing using a pozidrive screwdriver. Apply
torque of 6 Nm (4.42ft-lbs).
Breaker key lock Operation:
Use the following procedure to operate the
padlock:
1. Depress the OFF pushbutton on the breaker
front Fascia and extend/pull the breaker padlock
lever to its' outer position.
2. With the padlock lever extended, rotate one or
more of the keys anticlockwise. The key can then
be removed thus locking the breaker in its open
position.
3. With padlock lever extended, insert the key and
rotate in clockwise to unlock.
These instructions do not purport to cover all details or variations in equipment nor, to provide contingency to be met in connection
with installation, operation, or maintenance. Should further information be desired, or should particular problems arise which are not
covered sufficiently for the purchaser’s purposes, the matter should be referred to GE.
GE
41 Woodford Ave, Plainville, CT 06062
www.geelectrical.com
© 2009 General Electric Company
DEH-41407 R1 (03/09)
4