GE Industrial Solutions EntelliGuard G Command Closing Coil - Manual (Page 4)

14. Insert the push button and the spring from the
front of the fascia. Assemble them to the fascia
with the screw & washer as shown in fig 11.
Figure 12.
16. Ensure the fascia is aligned properly with the
trip unit and the pad lock features of the breaker.
17. Fasten the 6 mounting screws of fascia with
the housing using a pozidrive screwdriver. Apply
torque of 6 Nm (4.42ft-lbs).
Fig 11. Push button assembly
15
. To reinstall the cover, rotate the charging
handle down and slide the front cover over the
handle to assemble the front cover to housing as
shown in Fig. 12.
4