GE Industrial Solutions LC-LW015-Series - Manual (Page 2)

2 Lineage Power
Data Sheet
March 27, 2008 18 Vdc to 36 Vdc or 36 Vdc to 75 Vdc Inputs, 10 W and 15 W
LC/LW010- and LC/LW015-Series Power Modules:
Absolute Maximum Ratings
Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. These are abso-
lute stress ratings only. Functional operation of the device is not implied at these or any other conditions in excess
of those given in the operations sections of the data sheet. Exposure to absolute maximum ratings for extended
periods can adversely affect device reliability.
* Maximum case temperature varies based on power dissipation. See derating curves, Figures 43—45, for details.
Electrical Specifications
Fusing Considerations
CAUTION: This power module is not internally fused. An input line fuse must always be used.
This encapsulated power module can be used in a wide variety of applications, ranging from simple stand-alone
operation to an integrated part of a sophisticated power architecture. To preserve maximum flexibility, internal fus-
ing is not included; however, to achieve maximum safety and system protection, always use an input line fuse. The
safety agencies require a normal-blow, dc fuse with a maximum rating of 5 A (see Safety Considerations section).
Based on the information provided in this data sheet on inrush energy and maximum dc input current, the same
type of fuse with a lower rating can be used. Refer to the fuse manufacturer’s data for further information.
Parameter Device Symbol Min Typ Max Unit
Input Voltage:
Continuous
Transient (100 ms)
LC
LW
LW
V I
V I
V I, trans
0
0
0 —
—
— 50
80
100
Vdc
Vdc
V
Operating Case Temperature
(See Derating Curves, Figures 43—45.)
All T C –40 — 105* °C
Storage Temperature All T stg –55 — 125 °C
I/O Isolation All — — — 1500 Vdc
Table 1. Input Specifications
Parameter Device Symbol Min Typ Max Unit
Operating Input Voltage LC
LW
V
I
V
I
18
36 24
48 36
75 Vdc
Vdc
Maximum Input Current
(V
I
= 0 to V
I, max
; I
O
= I
O, max
; see Figures
1—4.)
LC
LW
I
I, max
I
I, max
—
— —
— 1.6
800
A
mA
Inrush Transient All I 2 t — — 0.2 A 2 s
Input Reflected-ripple Current
(5 Hz to 20 MHz; 12 µH source imped-
ance; T
A
= 25 °C; see Figure 33.)
All I
I
— 5 — mAp-p
Input Ripple Rejection (100 Hz—120 Hz) All — — 45 — dB