Asus ESC1000 Personal SuperComputer User Manual
Page 36
Advertising
Chapter 2: Hardware setup
2-16
2. Firmly hold the tray lever and pull
the drive tray out of the bay.
3. Take note of the drive tray holes.
Each side has three holes to fit
different types of hard disk drives.
Use two screws on each side to
secure the hard disk drive.
4. Place a SATA hard disk drive on
the tray, and then secure it with four
screws.
5. Carefully insert the drive tray and
push it all the way to the depth of
the bay until just a small fraction of
the tray edge protrudes.
When installed, the SATA connector on the drive connects to the SATA interface
on the backplane.
Advertising