Asus V6-P5G31E - Manual (Page 60)

4-22 Chapter 4: BIOS setup
Take caution when changing the settings of the PCI PnP menu items. Incorrect
field values can cause the system to malfunction.
4.4.6. PCI.PnP
The PCI PnP menu items allow you to change the advanced settings for PCI/PnP
devices. The menu includes setting IRQ and DMA channel resources for either
PCI/PnP or legacy ISA devices, and setting the memory size block for legacy ISA
devices.
Advanced PCI/PnP Settings
WARNING: Setting wrong values in below sections
may cause system to malfunction.
Plug And Play O/S [No]
Plug.And.Play.O/S.[No]
When set to [No], BIOS configures all the devices in the system. When set to
[Yes] and if you install a Plug and Play operating system, the operating system
configures the Plug and Play devices not required for boot.
Configuration options: [No] [Yes]
NO: lets the BIOS
configure all the
devices in the system.
YES: lets the operating
system configure Plug
and Play (PnP) devices
not required for boot
if
your system has a Plug
and Play operating
system.
Select Screen
Select Item
Enter Go to Sub-screen
F1 General Help
F10 Save and Exit
ESC Exit
The following items may only appear when a USB storage device is plugged.
USB Mass Storage Device Configuration
USB.Mass.Storage.Reset.Delay.[20.Sec]
Allows you to set the maximum time that the BIOS waits for the USB storage
device to initialize. Configuration options: [10 Sec] [20 Sec] [30 Sec] [40 Sec]
Emulation.Type.[Auto]
Allows you to set the emulation type. Configuration options: [Auto] [Floppy] [Forced
FDD] [Hard Disk] [CDROM]