Asus Vintage-AE1 - Manual (Page 37)

2 - 1 9 2 - 1 9 2 - 1 9 2 - 1 9 2 - 1 9 A S U S V i n t a g e - A E 1 A S U S V i n t a g e - A E 1 A S U S V i n t a g e - A E 1 A S U S V i n t a g e - A E 1 A S U S V i n t a g e - A E 1
2.9 Installing a floppy disk drive
The Vintage-PE1 system comes with one 3.25-inch drive bay for a floppy
disk drive.
To install a floppy disk drive:
1. Remove the front panel cover.
For instructions on how to remove the front panel cover, refer to page
2-3 of section “2.3 Removing the side plates and front cover”
2. Carefully insert the floppy disk drive into the floppy drive bay until the
screw holes align with the holes on the bay.
3. Secure the floppy disk drive with two screws.
4. Connect the floppy disk drive
signal cable to the signal
connector at the back of the
drive.
5. Connect the other end of the
signal cable to the floppy disk
drive connector on the
motherboard.
6. Connect a power cable from the
power supply unit to the power
connector at the back of the
floppy disk drive.
4 4 4 4 4
6 6 6 6 6