Asus BP5120 - Manual (Page 25)

2-3 ASUS BP5120
2.2 Preparation
Take note of the following precautions before you install components into the
system.
The system motherboard comes with an onboard standby power LED. This LED
lights up to indicate that the system is ON, in sleep mode or in soft-off mode, and
not powered OFF. Unplug the power cable from the power outlet and ensure that
the standby power LED is OFF before installing any system component.
P5KPL-VM
R
P5KPL-VM Onboard LED
SB_PWR
ON
Standby
Power
OFF
Powered
Off
• Unplug the power cables before you touch any component in the system.
• Use a grounded wrist strap or touch a safely grounded object or a metal
object, such as the power supply case, before handling components to
avoid damaging them due to static electricity.
• Hold components by the edges to avoid touching the ICs on them.
• Whenever you uninstall any component, place it on a grounded antistatic
pad or in the bag that came with the component.
• Before you install or remove any component, ensure that the ATX power
supply is switched off or the power cable is detached from the power
supply. Failure to do so may cause severe damage to the motherboard,
peripherals, and components.